ver.2016 r1
REPLACING HALOGEN BULBS
Your grill is engineered with the convenience of electrical power for illuminating and
igniting the grill.
To replace any oven light, follow the instructions below.
1. Turn all burner control knobs to the
OFF
position and shut off the gas supply to the
grill at the source (tank valve for propane units or gas line shut-off valve for natural
gas units.)
2. Disconnect supply of external electrical power to the grill.
3. Remove screw with a small Phillips
screwdriver. And insert a flat head
screwdriver into the housing as shown to
remove the glass cover. The glass cover
may be loose, ensure the cover is properly
supported before completely removing the
screw.
4. Remove old light bulb by pulling the bulb
out of the housing (make sure bulb is cool
before removal).
5.
Using a soft cloth or paper towel,
replace new light bulb into the housing
(finger prints left on the bulb may reduce its
life). Make sure the metal prongs on the
light bulb slip into the openings in the light
housing.
6.
Replace glass cover and re-snap metal clip into light housing.
Replace screw and tighten. To replace the other bulb, follow the
same procedure.
Toll Free: (855) 678-0088
bonfireoutdoor.com
Page 27
CAUTION:
Only replace with 12v / 10 watt halogen
bulbs.
WARNING:
To protect from potentially sharp sheet
metal and glass, wear gloves and safety
glasses during this procedure.
CAUTION:
Wait for the grill, oven, lens, light bulb,
and fixture to cool before proceeding to
the next step.
