Page 6
•
“FF” button or right arrow button (right button with embossed right arrow pattern)
•
“Mode” button (bottom button with an embossed cross pattern)
The sixth pushbutton is called “Selector” and it is used to rotate between the three available
applications “voice recorder with internal memory”, “voice recorder with a memory card”
and “MP3 player”.
Additional elements to be found on the casing are:
On the face side pointing away from the user: “Selector” button on the left, a USB connector
in the middle, and the connection for the battery charger on the right.
At the right end of the face side pointing towards the user: “headphone jack” (also called
“line-in”). This “headphone jack” additionally serves as the line-in entrance for recordings
directly through a cable instead of recordings by internal microphone.
On the long face side pointing to the right you find a 20 mm (0.79”) slot for SD/MMC memory
cards or hardware extensions.
On the left side of the keyboard in the corner pointing away from you: a small light emitting
diode which serves as a signal lamp. The speaker is located on the topside between the
keyboard and the edge closest to you. It can be felt through the 25 holes in the casing.
A connection loop for optional attachment of a carrying cord is cut horizontally from left to
right into the bottom of the casing close to the face side pointing towards you.
2.1.
Summary of operation of all functions
Task
Operation
Acoustic feedback
“On” from sleep mode
1 x any pushbutton on
topside
Application and current
folder
Selection of application
1 x “Selector
”
Application and current
folder
Increase volume
“Mode
”
+ right arrow
“Up
”
or voice message
Decrease volume
“Mode
”
+ left arrow
“Down
”
or voice message
Locking of keyboard
“Mode
”
+ “Rec
”
“Keyboard locked
”
Unlocking of keyboard
“Mode
”
+ “Rec
”
“Keyboard active
”
Memory status and battery
check
1 x “Mode
”
for 1.5 seconds “Internal memory
”
/
“Memory card
”
, space
available, battery status
Battery charging
Connection of charger or
USB cable
Long low pitched beep
(begin charging)
Short recording
“Rec
”
(keep pressed down) -
Start continuous recording “Rec
”
+ “Play
”
Sound sequence “low
pitched-high pitched
”
End continuous recording “Rec
”
Sound sequence “high
pitched-low pitched
”
