background image

1-866-771-2663  |  Page 3

•  Combustible material should not be within 72 inches of the top of the unit, or within 48 inches 
around the entire unit. 
•  Keep the appliance area clear and free from combustible material, gasoline and other flammable 
vapors and liquids.
•  If the flame goes out while burning, turn the gas valve off. Wait 5 minutes before repeating the initial 
lighting procedure. Once you have a flame started, hold down the control knob for 1 minute.
•  Do not add water into the unit. 
•  Do not operate unit if any part has been under water. Call a service technician to replace any 
damaged parts should this occur.
•  Do not disconnect any part while unit is in use. 
•  Do not store a spare propane tank on or near this unit.
•  If the heating unit is indoors, detach the propane tank and leave outdoors. 
•  Do not operate on a boat or vehicle. This unit must be used on a flat surface and outdoors ONLY. 
•  Always remove protective cover before operating (if applicable).
•  Do not set the protective cover over the unit until it is turned off and completely cooled down.
•  Check for leaks after not using the unit for long periods of time. 

•  Children should never operate this unit. Children must be supervised while near this unit.

•  Keep gas tank at least 5 feet away from unit when lit. (if external tank)
•  The maximum gas supply pressure is 250psi.

•  All installation and repair should be done by a qualified professional. This unit should be 
inspected annually and cleaned regularly.

•  Inspect all elements of this heating unit before each use. If there is damage, the burner must be 
replaced.  
•  Keep the hose out from any pathways to eliminate any accidental damage. (if external tank)
•  Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or 
injury. 
•  The gas supply tank should be constructed and marked with the specifications for the LP gas tanks 
of the U.S. Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas 
tanks, spheres and tubes for Transportation of Dangerous Goods; and Commission. 
•  The LP gas tank must have a listed overfilling prevention device and a QCCI or Type I, (CGA810) LP 
gas tank connection.
•  This heating appliance should not be used on plastic or artificial wood desks.

•  Children and adults should be alerted to the hazards of high surface temperatures and should 
stay away to avoid burns or clothing ignition.
•  Young children should be carefully supervised when they are in the area of the appliance.
•  Clothing or other flammable materials should not be hung from the appliance or placed on or 
near the appliance.
•  Any guard or other protective device removed for servicing the appliance shall be replaced 
prior to operating the appliance.
•  Installation and repair should be done by a qualified service person. The appliance should be 
inspected before use and at least annually by a qualified service person. More frequent cleaning 
may be required as necessary. It is imperative that the control compartment, burners and 
circulating airways of the appliance are kept clean.

 

 

  IF APPLICABLE:

•  Allow heating item to cool completely before placing on lid.
•  DO NOT use heating item while lid is installed. Always remove the lid while heating item is in use. 
 

Содержание Gatewood 50436















Отзывы: