Bona MiniEdge
Reassembly (Pict. 15 -18)
Distance of gap Line-up the holes consistently
15
Place the new belt on the belt pulley.
Twist the Bearing house while holding the pulley in such way that the
distance between the bearing housing and the pulley is the biggest and
the holes line up consistently.
(See picture15)
Place the whole package as it is, into the sanding arm, do not fasten the
bearing house.
Baring house and plate hub against each other with accompanied Textron wrench T15.
(See picture 16)
Assemble conical washer and nut.
If you turn the nut (with the box wrench) clockwise the exocentric bearing house turns in a way that the
belt tightens.
(See picture 17)
Turn until the belt is tight enough and the screw holes to the bearing house on the top of the arm line up.
(See picture 18)
Assembly the four screws and to the bearing house and then proceed with the dust and belt cover plates.
N.B.
Check that the bearing housing place is clean and dust free prior to reassembly.
19
16 17 18
Replacing the dust bag (Pict. 19)
Unplug the machine. Loosen the Velcro band at the dust tube.
Change dust bag and pull the cable tie on each side of the stop ring
on the tube. Put the tube with the bag back on the machine.
12
