9
4430 Gibsonia Rd. • Gibsonia, PA 15044 • USA • www.bontool.com
Assembly
The Bon Floor Stripper is shipped from the
factory secured on a specially designed wooden pallet
and protected from external damage by a corrugated
carton or wood crate. If shipped with a corrugated
carton, the Surface Grinder is secured to the pallet
with wood support strips. Remove the carton or crate
immediately upon receipt using suitable tools to
remove the nails.
R E M O V I N G T H E B o n F l o o r S t r i p p e r
F R O M T H E PA L L E T.
Tools Required:
1 each - cutting type pliers
1 each - claw hammer or a hammer and an
appropriate pry bar
Remove the corrugated carton which is fastened to
the pallet. The Bon Floor Stripper is secured to the
pallet with banding. Using the pliers, cut and remove
the banding. The Bon Floor Stripper can then be
removed from the pallet.
W E A R S A F E T Y G L A S S E S A N D O T H E R
APPROPRIATE SAFETY APPAREL WHEN
CUTTING THE BANDING AND/OR REMOVING
T H E C O R R U G AT E D / W O O D S H I P P I N G
CRATE.
Included in the shipment should be the following:
1 each - Bon Floor Stripper main frame assembly
1 each - Extension cord with integral GFI
1 each - Adjustable section of the operator handle
1 each - Pack of standard blades
The Bon Floor Stripper is shipped from the factory
completely assembled with the exception of the
adjustable section of the operator handle. If ordered
with the Bon Floor Stripper, optional blades and
accessories can be shipped separately or included in
the shipping container.
Visually inspect the shipment for freight damage
and/or missing parts. If shipping damage is evident,
contact the delivering carrier immediately to arrange
for an inspection of the damage by its claims
representative. Federal law requires that a claim be
filed within a specific time period. If missing parts are
detected, notify your dealer or the Customer Service
Department who will assist you in obtaining them.
Check all fasteners for proper security. Consult a
fastener torque chart for the proper torque value if any
fastener is found to require retorquing.
I N S TA L L AT I O N O F T H E A D J U S TA B L E
S E C T I O N O F T H E O P E R AT O R H A N D L E .
The installation of the adjustable section of the
operator handle will require a level working surface of
sufficient size and appropriate height.
1) The Bon Floor Stripper incorporates an operator
handle design that folds for transport and storage.
The handle is secured to the main frame at two loca-
tions; a pivoting (fixed) location secured by Allen head
type cap screws and a retaining (locking) location
secured by removeable, ball-detent type pins. The
pins are secured to the main frame by lanyards.
2) To place the operator handle in the work position,
move the handle upright so that the ball-detent pins
can be inserted through the operator handle and main
frame. Determine the ball-detent pins are properly
inserted through the operator handle and main frame
to fully expose the ball detent. FIGURE 1.
FIGURE 1
THE BALL DETENT MUST BE FULLY
EXPOSED AGAINST THE MAIN FRAME TO
PROVIDE THE PROPER PIN RETAINING
FORCE. AN IMPROPER PIN RETAINING
CONFIGURATION CAN RESULT IN
UNEXPECTED OPERATOR HANDLE
