76
Inlet Clearance System (ICS)
Mechanisms
Use Sea-Doo synthetic grease and lu-
bricate as follows:
From underneath of hull, lubricate wa-
ter intake grates at pivoting points and
cable rods using Bombardier Lube™
lubricant.
TYPICAL
1. Lubricate cable rod
2. Lubricate pivoting points
Anticorrosion Protection
Throttle Cables
Lubricate throttle cables with Bombardier
Lube™ lubricant every 25 hours of use
(every 10 hours in salt water use).
Electrical Connections
As necessary, apply dielectric grease
on battery posts and all exposed cable
connectors including stern light con-
nectors on mast and boat.
CAUTION:
Do not lubricate connec-
tors of the Interface and the engine
Electronic Control Units (EMS ECU).
Additional Lubrication
Bombardier Lube lubricant will help to
prevent corrosion and keep proper op-
eration of moving mechanisms.
Lubrication of the following items
should be performed every 50 hours in
fresh water use but every 10 hours in
salt water use.
Rear Storage Compartment Cover
Mechanism and Hinges
TYPICAL
Ski Post
Lubricate ski post through all its length.
Pull out then push in several times to
distribute the lubricant.
Step
: Lift ski post to lubricate
Step
: Lubricate here
Step
: Move post up and down several times
to distribute lubricant
Reverse Gates
Lubricate pivoting points and mecha-
nism on both sides of each gate.
F09J03Z
1
2
F04L69Y
F04L9BY
1
2
3
1
2
3
lmo2004_002a.book Page 76 Wednesday, May 14, 2003 11:10 AM
Содержание SeaDoo Speedster 200
