68
Flushing
To flush the exhaust cooling systems,
start each engine
then
immediately
open the water tap.
CAUTION:
Never flush a hot engine.
Always start each engine before
opening the water tap. Open water
tap immediately after each engine is
started to prevent overheating.
Run each engine about 20 seconds at
a fast idle between 4000 - 5000 RPM.
CAUTION:
Never run engines with-
out supplying water to the exhaust
cooling systems when sport boat is
out of water.
Ensure water flows out of jet pumps
while flushing. Otherwise, refer to an
authorized Sea-Doo dealer for servicing.
CAUTION:
Never run engines longer
than 5 minutes. Drive line seals have
no cooling when the sport boat is out
of water.
Close the water tap,
then
stop the en-
gine.
CAUTION:
Always close the water tap
before stopping the engine.
Anticorrosion Treatment
To prevent corrosion, spray a corrosion
inhibitor (salt water resistant) such as
Bombardier Lube™ lubricant or equiva-
lent over metallic components in en-
gine compartment.
NOTE:
Engine fogging should be done
with Bombardier Lube lubricant when-
ever the sport boat is to be stored for
few days or a long period.
Apply dielectric grease (salt water re-
sistant) on battery posts and cable con-
nectors.
CAUTION:
Never leave rags or tools
in the engine compartment or in the
bilge.
WARNING
Certain components in the engine
compartment may be very hot. Di-
rect contact may result in skin burn.
Do not touch any electrical parts or
jet pump area when engine is run-
ning.
lmo2004_002a.book Page 68 Wednesday, May 14, 2003 11:10 AM
Содержание SeaDoo Speedster 200
