Bomar SV 330 DGH, Руководство по эксплуатации

Страница: 58 / 113

58
Manual version: 2.00/May 2016
Manual rev.: 2
Ú
d
rž
b
a
s
tr
o
je
W
a
rt
u
n
g
M
a
c
h
in
e
s
e
rv
ic
e
4.6.3. Spots for lubrication
There are several spots on the machine, which are to be greased periodically
to secure a correct function of the machine.
Lubricator Procedure
Linear guiding rails of the saw arm
Lubricators are located on the inner
side of the track; accessible from
bottom.
Lubricate with grease once in three
months (see chapter Lubrication
greases). Use 3–5g of grease on every
carriage of the linear guiding system.
Use a greasing gun. Perform 3–5 runs
across the whole track for lubrication.
4.6.4. Hydraulic oils
Replace the hydraulic oils once every 2 years, because the oil properties will
deteriorate and cause problems with the hydraulic unit. If the hydraulic system
is equipped with a filter (2SF 56/48-0,063), replace the filter as well.
Use oils with specification DIN 51524-HLP, ISO 6743-4 and viscosity class ISO
VG 32 in hydraulic aggregates.
Note:
When replacing, use oils recommended by BOMAR or
oils, from the other manufacturers which have
comparable parameters. Do not forget, that mineral
and synthetic oils must not be mixed!