BOMANN WA 5712, Руководство пользователя, Страница: 7 / 20

7
09/2013
Feet Adjustment (level adjustment)
Take care to a firm and horizontal position of the washing machine. If the machine moves, adjusts the
feet. Loosen the locknuts with a spanner.
Adjust the feet: Using the spanner, turn it locknut in a clockwise direction. Then turn locknuts togeth-
er with adjust feet to unscrew. Hold adjusts feet securely with a pipe wrench. Turn locknut again using
the spanner until it sits firmly up against the housing.
Use a spirit level to check the machine is stand-
ing level.
The machine must stand perfectly level on all four feet to ensure safe and proper operation. Incorrect
installation may increase electricity and water consumption and may cause the machine to move
about.
NOTE:
- The locknuts must be tightened after adjustment. Any looseness can cause vibration and noise.
- The feet must never be removed. Do not restrict the floor clearance through deep pile carpets,
strips of wood or similar. This might cause heat build-up which would interfere with the operation of
the appliance.
Water Connection
Install the Water Inlet Hose (Cold Water)
Use the new included inlet hose to connect the machine at the water supply (cold water). Old hose-
sets should not be reused. Installation should comply with local water authority and building regulation
requirements.
- Connect the water supply hose to the tap with a 3/4"thread and tighten it firmly to the right.
- Connect the other end of the inlet hose to the inlet valve on the back of the device and tighten it
firmly to the right too.
NOTE: If a leak develops remove the inlet hose and reconnect. Connect to a standard water tap.
Install the Water Drain Hose
There are two ways to place the end of drain hose:
- 1. Hang into a sink or trough.
- 2. Connect it to the branch drain pipe of the trough.
1. If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in
the drain hose to prevent waste from the sink entering the washing machine.
Min. inlet water pressure 0.05 MPa
Max. inlet water pressure 1.0 MPa