BOMANN SBS 7324 IX, Инструкция по эксплуатации

Страница: 20 / 28

20
-
near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
-
Do not expose the appliance any weather.
Levelling the appliances doors Levelling the appliances doors Levelling the appliances doors Levelling the appliances doors
If the doors are not at the same level and do not
close parallel to each other, the refrigerator door
must be aligned.
Maximum tolerance compensation Maximum tolerance compensation Maximum tolerance compensation Maximum tolerance compensation is 5 mm! is 5 mm! is 5 mm! is 5 mm!
Open the door, loosen the locknut (2) with a wrench
(3)..
..
if the refrigerator door is too low
, turn the adjusting
nut (1) cou cou cou counterclockwise nterclockwise nterclockwise nterclockwise to raise the door.
..
if the refrigerator door is too high
, turn the adjusting
nut (1) cloc
cloc cloc
clockkkkwise
wise wise
wise to lower the door.
Once the doors are aligned, retighten the locknut (2).
Electrical
Electrical Electrical
Electrical connection
connection connection
connection
WARNIN
WARNIN WARNIN
WARNING
G G
G::::
•
The installation to the mains supply must conform
to the local standards and regulations.
•
Improper connection may cause to an electric electric electric electric
shock shock shock shock!
•
Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
•
The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
•
Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
•
Connect the mains cable to a properly installed
and earthed wall outlet.
•
If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Startup / Operation Startup / Operation Startup / Operation Startup / Operation
Prior to first use
Prior to first use Prior to first use
Prior to first use
C C C CAUTION AUTION AUTION AUTION::::
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter “Cleaning and Maintenance”.
Control panel Control panel Control panel Control panel
GENERAL NOTE: GENERAL NOTE: GENERAL NOTE: GENERAL NOTE:
•
About 10 seconds after the last button press, the
control lamps stop flashing and the settings are
activated.
•
About 60 seconds after the last button press, the
display will enter the standby mode.
The standby mode is terminated as soon as but-
tons are pressed, or device door is opened.