23
so observe the storage information on the pack-
aging of the merchandise.
General safety precautions
General safety precautions
General safety precautions
General safety precautions
•
Do not exceed the maximum freezing capacity.
See data under "Technical Data" and on the rat-
ing label.
•
Do not store bottles or cans. These can break
when the contents freeze – or even explode, if
they contain carbonated drinks.
•
Once products have been defrosted halfway or
completely, they should be consumed as soon as
possible and should not be frozen again, except
they have been processed to a ready meal.
•
Do not open the door in case of power failure. If
the failure does not take longer than 10
10
10
10 hours
hours
hours
hours, the
food will not be affected.
•
Do not eat food that is still frozen. Do not eat ice
cream directly from the freezer. The cold can
cause injuries in the oral cavity.
•
Touching metal parts inside the appliance can
cause symptoms similar to burns if the skin is very
sensitive.
•
Never touch frozen food with moist or wet hands.
Water dispenser
Water dispenser
Water dispenser
Water dispenser
Fill water tank with water
Fill water tank with water
Fill water tank with water
Fill water tank with water
The maximum capacity of the water tank is 3 litres,
do not exceed.
Leave the water in the container for at least 4 hours
with the door closed so that it can become cool.
To fill the water tank with water there are 2 variants:
1)
Open the small cover on the big cover of the
water container and fill the water into the
container through the opening
2)
Remove the big cover of the water container
and fill the tank directly.
Use the water dispenser
Use the water dispenser
Use the water dispenser
Use the water dispenser
When the water tank is empty, do not push the dis-
penser lever strongly as this can damage the mech-
anism.
Do not touch the dispenser lever without a cup un-
derneath the dispenser.
1.
Before dispensing the water you have to ensure
all parts are correctly fitted and that the door of
the appliance is closed.
2.
Place an appropriately
sized container or cup
into the dispenser and
push the dispenser lever.
3.
Once a sufficient amount of water has been dis-
pensed remove the container or cup away from
the dispenser lever.
Cleaning of the dispenser
Cleaning of the dispenser
Cleaning of the dispenser
Cleaning of the dispenser
Clean all parts of the
water container and the
dispenser using hot
soapy water before you
use the dispenser for the
first time.
You have to remove the
water container for
cleaning. Hold both
sides of the container
tightly, then lift and re-
move it from the door at
an angle of 45°.
Remove the seal ring
from the water tank by
gently pulling it from the
bottom of the water tank.
Gently insert a flathead-screwdriver between the
edge(s) of the water valve and the dispenser mould-
ing. Lift the edges on both sides of the water valve
slowly and carefully using the screwdriver. The wa-
