7
04/2012
Electrical connection
•
The kind of current (AC) and the voltage must be conform to the data of the rating label, located in-
side or outside on the back of the unit.
•
In case of heavy voltage fluctuations, it is recommended to use an automatic alternating current reg-
ulator.
•
The plug, together with the grounding conductor, must fit into the wall socket. The mains plug must
be freely accessible.
•
If the appliance is brought in from the cold (temperature is not higher than +12 °C), you should wait
for two hours before connecting it to the mains.
•
The appliance should not be connected to the mains until all packing and transport materials aren’t
removed. Once the appliance is unpacked, make sure that it is complete, that the body and the elec-
trical cord aren’t damaged.
It is forbidden to use a technically damaged appliance!
Mains cable
•
Do not extend or roll up the cable during operation.
•
Also, the cable must not be near the compressor on the rear side, since latter one gets hot during
operation. In case of any contact, the isolation would be damaged resulting in electric leakage.
•
The use of extension cables is not recommended.
•
Do not connect the device to the mains with wet hands.
•
Install the device for the wall socket to be freely accessible.
R
EVERSE
T
HE
D
OOR
O
PENING
If required, the door openings can be moved from the right (supplied condition) to the left side.
WARNING
When replacing the door stops, the device must be disconnected from the power supply.
WARNING! Turn off the appliance and pull the plug out of the electricity supply socket.
It is recommended that changing the opening direction of the doors should be done with a helper. You
will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the refrigerator horizontally.
Do the actions below in the order they are listed:
1. Remove the covers
c
from the body of the appliance and of the inner side of the door. Also
remove the upper bracket
6
together with the nut and washers and the spacer under the
bracket.
2. Remove the door of the refrigerator compartment. Remove the stopper
5
from the bottom of it.
On the other side of the door attach the stopper intended for doors that open on the left (you
will find it in the packet).
3. Remove the middle bracket
4
together with the washers on the axle and the plastic spacer.
4. Remove the freezer compartment door
3
. Remove the bottom cover
1
.
5. Remove the bottom bracket
2
together with the washers on the axle and the plastic spacer.
Unscrew the axle with the washers and screw it into the aperture provided on the other side.
6. Remove the bottom bracket
7
and in its place attach the other bottom bracket
2
together with
the washers on the axle and the plastic spacer. Fix this bracket
7
in place of the other bracket
2
.
7. Remove the covers
8
from the partition separating the refrigerator compartment from the
freezer compartment and place them in the apertures on the other side.
8. Remove the covers
9
from the doors of the refrigerator compartment and the freezer com-
partment and place them in the apertures on the other side.
9. Hang the freezer compartment door on the axle of the bracket
2
.
10. Turn the bracket
4
around 180° together with the washers on the axle and the plastic spacer,
transferring the washers to the axle on the other side of the bracket. Once the bracket is at-
tached to the freezer compartment door, fix it in place on the other side of the appliance.
11. Hang the refrigerator compartment door on the axle of the bracket
4
.
