7
•
Turn the adjusting screws as needed in the
clockwise or counterclockwise direction. The steel
cable tightens or loosens.
•
Check the door spring tension. If the door remains
fully open horizontally and can still be easily
closed, the tension is correct. Otherwise do the
adjusting again.
Connection to the water supply
Connection to the water supply
Connection to the water supply
Connection to the water supply
Connect the water inlet hose as well as the water
drain hose properly. Follow the instructions that we
give you under "Water connection".
Installation to the power supply
Installation to the power supply
Installation to the power supply
Installation to the power supply
Consider the instructions that we give you under
"Electrical connection".
Adjusting the feet
Adjusting the feet
Adjusting the feet
Adjusting the feet
Place the appliance in its proper position and take
care that it is leveled solid and horizontal. Check this
with a spirit level.
The maximum adjustment
height of the feet is
50 mm.
•
You can adjust the back foot by the adjusting
screw (aaaa) at the center of the appliance plinth front
with an Allen key.
•
Adjust the front feet (bbbb) with a screw-wrench until
the dishwasher is leveled.
Fixing the dishwasher
Fixing the dishwasher
Fixing the dishwasher
Fixing the dishwasher
Fix the appliance by
tighten the screws
from the appliance
inside to the provid-
ed holes accordingly.
A.
A.
A.
A.
If the worktop made of wood, fasten the appliance
to the worktop.
B.
B.
B.
B.
If the worktop made of marble or granite, fasten
the appliance sideways with the housing unit. Put
the screw covers on.
Water connection
Water connection
Water connection
Water connection
CAUTION:
CAUTION:
CAUTION:
CAUTION:
•
The Installation of the water supply must conform
to the local laws and regulations.
•
The appliance is not
not
not
not suitable for hot water supply.
•
Use the new supplied hose set to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
•
If the water pipe is new or long time not used,
ensure before connecting to the water system,
that the water is clear and free from contamina-
tion.
Notes on inlet hose safety system (delivery scope
Notes on inlet hose safety system (delivery scope
Notes on inlet hose safety system (delivery scope
Notes on inlet hose safety system (delivery scope
depending on model)
depending on model)
depending on model)
depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop,
www.bomann
www.bomann
www.bomann
www.bomann----germarny.de
germarny.de
germarny.de
germarny.de
. To order, use the
reference number found under “Technical Data”.
Connect the water inlet hose (cold water connection)
Connect the water inlet hose (cold water connection)
Connect the water inlet hose (cold water connection)
Connect the water inlet hose (cold water connection)
NOTE
NOTE
NOTE
NOTE::::
The water pressure must be between 0.04-1.0 MPa.
With higher pressure: use a pressure regulator.
•
Connect the water inlet hose to a
water thread with ¾“. Screw the
hose firmly in the direction of the
screw thread; pay attention for a
tight fit.
•
Connect the other end of the inlet
hose to the inlet valve on the ap-
pliance back; pay attention for a
tight fit too.
Содержание GSP 857 IX
Страница 19: ...19...
