NOTE
NOTE
NOTE
NOTE:::: Recomm
Recomm
Recomm
Recommendations for
endations for
endations for
endations for preparation work
preparation work
preparation work
preparation work
•
When installing, ask another person
•
Wear protective gloves to prevent injuries from any sharp edges.
•
Determine the position of the extractor hood centrally above the hob in
safety distances.
•
Align the drill template horizontally and
spirit level.
•
Drill Ø 8 mm mounting holes into the wall and insert the dowel pins.
•
Then rotate the mounting screws 2 x ST10
mm from the wall.
•
Before suspending the hood, the connecting piece with the non
extractor duct with the screws 4 x ST10*10 mm.
•
Now secure the hood by fixing the mounting
holes.
For extraction mode:
For extraction mode:
For extraction mode:
For extraction mode:
•
Attach the supplied flexible extraction
the connecting piece with non-return valves. C
outside.
•
Remove the protective plastic from the telescopic duct.
•
Slide the inner (upper) duct along the slide fixture into the outer (lower) duct. Make sure that the inner duct
is aligned with the vents (A) at the
•
Put the duct cover on the hood. Determine the extension length of the duct cover by pulling up the inner
duct or sliding back into the outer duct.
•
Attach the mounting rail for the duct cover on the upper duct ending
wall and insert the dowel pins. Use the screws 2 x ST10*50 mm to secure the rail.
•
For extraction mode, correctly position the flexible
20
preparation work
preparation work
preparation work
preparation work
person to assist.
Wear protective gloves to prevent injuries from any sharp edges.
Determine the position of the extractor hood centrally above the hob in conformance with the
the drill template horizontally and mark the necessary holes for the wall mountin
Drill Ø 8 mm mounting holes into the wall and insert the dowel pins.
Then rotate the mounting screws 2 x ST10*50 mm in the upper holes as far as
the connecting piece with the non-return valves must be installed onto the
extractor duct with the screws 4 x ST10*10 mm.
the mounting screws 2 x ST10*50 mm through the hood body in the lower
extraction hose with an inner diameter of Ø 120 mm onto
return valves. Connect it with the extraction outlet to the
Remove the protective plastic from the telescopic duct.
Slide the inner (upper) duct along the slide fixture into the outer (lower) duct. Make sure that the inner duct
the top.
Put the duct cover on the hood. Determine the extension length of the duct cover by pulling up the inner
duct or sliding back into the outer duct.
the mounting rail for the duct cover on the upper duct ending. Drill Ø 8 mm mounting holes into
wall and insert the dowel pins. Use the screws 2 x ST10*50 mm to secure the rail.
For extraction mode, correctly position the flexible extraction hose.
formance with the specified
wall mounting. Check them with a
mm in the upper holes as far as these stick out about 20
return valves must be installed onto the
the hood body in the lower
Ø 120 mm onto
extraction outlet to the
Slide the inner (upper) duct along the slide fixture into the outer (lower) duct. Make sure that the inner duct
Put the duct cover on the hood. Determine the extension length of the duct cover by pulling up the inner
Drill Ø 8 mm mounting holes into the
Содержание DU 654 G
Страница 27: ...27 ...
