BOMANN 774160, Инструкция по эксплуатации

Страница: 10 / 24

10

Remove the lower basket and unscrew the lid of
the salt container.

Add about 1.5 kg of salt by using the supplied
funnel tube.

Full fill the salt container with water (just before
the first use).

Screw the lid firmly on again after filling the con-
tainer.

Depending on salt resolution, the warning lamp
usually disappears immediately after filling.
B.
Fill the rinse aid dispenser
Function of rinse aid
The rinse aid is automatically added during the final
rinse, ensuring thorough rinsing and a spot and
streak free drying.
When to refill the rinse aid dispenser
If the corresponding message
does not light up in the display,
you can estimate the amount
of remaining rinse aid to the
optical level indicator (D) next to the dispenser.
When the rinse aid dispenser is full, the indicator is
completely dark. If the rinse aid diminishes, the size
of the black dot changes as shown below. In order to
avoid spotting, the rinse aid level must not drop be-
low ¼.
full ¾ full ½ full ¼ full empty
Fill in the rinse aid

To open the dispenser, screw the lid counter-
clockwise to the open position and remove the lid.

Add the rinse aid into the dispenser, being careful
not to overfill. The dispenser contains approx.
110 ml.

Before closing the appliance door, put on the lid in
the open position back and turn it clockwise to the
closed position.
NOTE:
Remove spilled rinse aid with an absorbent cloth to
avoid excessive foaming during the next rinse.
Adjusting the rinse aid dosage
When forming spots and the dishes dries poorly,
increase the added amount of rinse aid. You can set
the amount of addition between level 1 (min.) and
level 6 (max.).
Take off the lid of the rinse aid dis-
penser and adjust the dial to the de-
sired level. The factory setting is “4”.
NOTE:
Increase the dosage if there are drops of water or
lime spots on the dishes after rinsing. Reduce the
dosage if there are sticky whitish stains on dishes or
a bluish film on glassware or knife blades.
C. Fill in detergent
Function of detergent
Detergents with its chemical ingredients are neces-
sary to remove dirt, crush dirt and transport it out of
the dishwasher. The most commercially, high-quality
cleaning agents are suitable for this purpose.
Detergent
Normally new pulverized detergent is without phos-
phate. Thus, the water softener function of phos-
phate is not given. In this case we recommend filling
salt in the salt container even when the hardness of
water is only 6°dH. If detergents without phosphate
are used in the case of hard water often white spots
appear on dishes and glasses. In this case add more
detergent to reach better results. Detergents without
chlorine do only bleach a little. Strong and colored
spot will not be removed completely. In this case
choose a program with a higher temperature.