Bolt VS-560S, Руководство пользователя

Страница: 32 / 44

32
|
Using Your VS-560S as a Wireless Manual Flash
4. Press the up or down buttons to select the channel
and the group. The flash will cycle through channel
1, groups A through C, and then channel 2, groups
A through C, and so on. The numbers represent the
channel, while the letters represent the group.
A. When using a single flash, set it to the same
group and channel as the master.
B. When using multiple flash units, select the
same group and channel for all units being used in a particular light position. For example, if you are
using three VS-560S units, you might want to set two as a main light on channel 1, group A, and set
the third as a fill light on channel 1, group B.
5. If desired, adjust the flash coverage angle by pressing the Zoom button repeatedly.
6. Make sure that the red light on the front of the flash is flashing. This indicates that the unit is ready to fire
in wireless TTL slave mode.
Using Your VS-560S as a Wireless Manual Flash
For even greater creative control, you can set the output levels of your remote flash units manually.
GROUP B