16
Control the camera using HDBaseT Receiver
1.
Must set the camera in RS232 control method on Bottom Dip Switch
.
2.
Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you are using.
3.
Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
4.
Device supports RS232 and RS422/485 control.
5.
RS232 on HDBaseT receiver does not support daisy chain control.
6.
Use Cat 6 network cable to connect from the camera HDBaseT port to HDBaseT Receiver input port.
7.
HDBaseT will provide the power to the camera via the network cable.
8.
Make the control connection in between HDBaseT Receiver and keyboard as following:
RS232/RS422 Control Connection between the HDBaseT receiver and the controller:
To make the RS232/RS422 control cable connection between the HDBaseT receiver and the controller:
1.
Use CAT6 network cable to make the RJ45 connector to connect to the HDBaseT Receiver control port.
a)
RS232: Make RJ45 connector for HDBaseT Receiver RS232 port as following:
