13
An application software that supports this unit is needed if you use PC station.
RS232 Connection
1.
Set RS232 control method on Bottom Dip Switch.
2.
Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you are using.
3.
Set specific camera address that you want to control the camera for on Bottom Dip Switch.
4.
If you want to have the camera address to be automatically assigned by VISCA controller, set camera Dip Switch address to
0.
5.
Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
6.
Use the RS232 control connection cable provided by third party controller (VISCA). The controller must be
VISCA compatible.
7.
Camera supports Daisy Chain in RS232 control mode by using extension cables (Included). Have to use 8-Pin
Mini Din Serial RS232 Cable (Not included) connection for the controller.
HDBaseT Receiver does not
support RS232 daisy chain connection.
8.
You can make RS232 connection cable if you have the following applications:
9.
Use extension cable included RJ45 to RS232 8 pin Mini Din adaptor to make RS232 connection for your control
device.
10.
Or you can use CAT5/6 network cable to make RS232 connection by following the pin definition below:
