11
Conductor:
AWG
Stranding
Material
Nominal Diameter
18
Solid
Bare Copper
0.04 in.
Shield Material
Nom. Capacitance
Conductor to shield
Nom. Inductance
Nom. Char. Impedance
16.2 pF/ft
0.106 µH/ft
75 Ohm
Obtain Video Signal
The camera can simultaneously have SDI video output and HDMI video output and IP video output.
HDMI HD Video signal
1.
Connect the camera to a HD monitor/TV using HDMI cable.
2.
Turn on the camera, video will display on the monitor after running initializing.
3.
Information of the camera initial setting status will display for 5 seconds.
4.
You can set the video format of the camera to the one you want to display.
SDI Video Signal
The camera can simultaneously stream SDI video output with HDMI video output.
1.
Connect SDI cable in between the camera your SDI Device/display.
2.
You now have SDI video output.
3.
SDI video only supports 1080P.
IP Video Signal
The camera can simultaneously stream IP video output and SDI video output and HDMI video output.
1.
Connect the camera to the network using Cat5/Cat6 network cable.
2.
You need to have a web browser or VMS client software ready for IP video streaming.
3.
PELCO address and Baud Rate setting on the camera must be as same as the setting on camera IP WEB
interface.
4.
To obtain IP video and configure IP video, please refer to Network Camera User Manual Part Two.
CVBS Video Signal
1.
Connect CVBS cable in between the camera and your CVBS Device/display.
2.
You now have CVBS video output.
Camera Initial setting status Information
Type
Layer
Material
Coverage
Tape
1
Aluminum / Polyester / Aluminum 100%
Braid
2
Tinned Copper
95%
