Bolin Technology BC-9 Series, Руководство пользователя, Страница: 45 / 57

45
When this item is set to ON, the message of the camera configuration appears for about 10 seconds on the
screen, after the camera is powered on or rebooted.
PRESET MEMORY:
This feature allows you to save the image parameter to PRESET memory, turn it on to save most image
parameters like as picture, white balance, exposure, focus mode, zoom positions when you call the preset.
FACTORY RESET
You can select this item to set camera back to Factory Default setting by pressing HOME button to confirm the
action. All data of the camera that have been set will be deleted.
TALLY MODE
When the tally mode is set to ON, the tally light on the camera will be turned on.
If you connect the camera with Bolin keyboard controller, you can set the GPI I/O to Output mode in Keyboard
Setting, then you can do tally control via the keyboard directly.
OPERATING LED
This item is set to OFF by default. You can turn it on and select different color for the operating LED which is
surround the camera Lens.
You can select Red, Green, Blue and White color to display on the operating LED. While the operating LED is
on, if you make any operation sending commands to the camera via keyboard or IR controller, the LED will be
flashing indicating command receiving.
LED BRIGHTNESS
LED brightness level: LOW, MID and HIGH.
AUDIO
This item is set to OFF by default, user can set it to ON to enable camera MIC to capture audio signal.
RELOAD PRESET 1:
When this item is set to ON, preset 1 is set to Home position. The camera goes to Home position when it is
powered on or reset.
VIDEO FORMAT:
This Video Format selection will determine the video format of both SDI and HDMI.
You can change the video format by adjusting this item. Select the item, press “←” button to choose the video
format you want to set to, then press “→” (Pressing “→” button changes value on some product models) or
HOME button to confirm it. After you confirm your choice, press HOME button again to restore it. The camera
will reboot by itself. The new video format is activated.
You can cancel it by pressing the MENU button.
The video formats that you can select from are:

2160P: 29.97/25/23.98/24

1080P: 60/59.94/50/30/29.97/25/23.98/24

1080I: 60/59.94/50

720P: 60/59.94/50
*When you select 4K video format 2160P, it will show
extra selection for you to make for selecting SDI output
format:

Dual-Link 3G-SDI mode. In this mode, you
can use Dual-Link 3G-SDI with two SDI BNC
connectors device to display video.

Single 6G-SDI mode. In this mode, you can use
single 6G-SDI with one SDI BNC connector
device to display video.
You can make the selection according to your backend
video switcher equipment.
MCU FW:
Software Version Number of MCU that is currently running on the camera, you may need this information for
technical support.
FPGA FW:
Software Version Number of FPGA that is currently running on the camera, you may need this information for
technical support.
EXPOSURE
WHITE BALANCE
DETALL
> PICTURE
GAMMA
NETWORK
PAN TILT ZOOM
>SYSTEM
OSD
PELCO ID 001
IR-RECEIVE ON
DISPLAY INFO ON
PRESET MEMORY ON
FACTORY RESET
TALLY MODE OFF
OPERATING LED OFF
LED BRIGHTNESS HIGH
AUDIO OFF
RELOAD PRESET 1
ON
VIDEO FMT 2160P29.97
SDI: DUAL-LINK 3G-SDI
MCU FW: VOK010B350401A002
FPGA FW: V255
SYSTEM MENU