11
Figure 2.2.4.
Drilling Template
Mounting on a Wall:
-
Please ensure that the wall the unit is to be mounted onto is solid, flat, clean, and dry;
-
Drill three holes in the wall: two upper ones and a lower one;
-
Insert wall plugs to the holes and screw provided woodscrews into the two upper holes so that
distances between a screw head and the wall is about 7
mm;
-
Remove the cover from the unit;
-
Hang the unit on the two screws. Screw the third screw into the lower mounting hole and fasten
the unit to the wall;
-
Connect electric wires to the unit as per the project design documentation and the connection
diagram;
-
Close the unit with its cover;
-
To dismantle the unit, please follow all the steps in the reverse order.
Mounting on a DIN-rail:
-
Install the unit on the DIN rail;
-
Remove the cover from the unit;
-
Connect electric wires to the unit as per the project design documentation and the connection
diagram;
-
Close the unit with its cover;
-
To dismantle the unit, please follow all the steps in the reverse order.
It is acceptable to use mounting enclosures (cabinets, boxes, etc.) for installation. If the unit and
other units are arranged adjacently then vertical and horizontal distances between them shall be at
least 10 mm each.
