bolid S2000-K, Руководство пользователя

Страница: 30 / 50

Orion ISS
www.bolid.com
30
The specified address of the S2000-К can be unset to its factory value (127). To do this, remove the
keypad top cover and press the tamper switch by long-long-long-short pressing. Here the “long”
means “for more than 1 s” while the “short” means “for no more than half of a second”. The pauses
between pressings shall not exceed half a second each.
Programming the S2000-K to Display Events and Indicate Alarms
In order the S2000-K keypad can display system events received from the network controller, the
special keypad option, Display Events , must be enabled. If, moreover, the keypad is supposed to in-
dicate system alarms by flashing its LED and issuing various sound signals, the Indicate Alarms key-
pad option must be activated.
WARNING! In order to use the keypad for displaying messages and indicating alarms you MUST AL-
SO REVISE settings of the network controller (see page 31).
By default, displaying system event messages and indicating alarms are disabled for an S2000-K.
To activate these options, double click the left mouse button on the proper field or select the relevant
option and set the proper value from the dropdown list at the top right corner of the program window
(see Figure 3). Note, that alarms can be indicated only if events are being received from the network
controller, so always enable the Displaying Events option when you have activated the Indicate
Alarms option .