OPERATION MANUAL
RotoMidi
10
2.1 Preparations and use
Warning! This section contains important safety instructions. Failure to
comply can be dangerous for the user.
Check the direction of rotation and RPM of the equipment. Check the direction
of rotation setting on the equipment’s control panel (forward / reverse). RPM is
also controlled from the control panel, using the dedicated rotary switch. To
increase RPM, turn the switch clockwise.
1. Insert the tool mounted onto the flexible shaft fully inside the pipe to be
machined.
2. If the red Emergency Stop button is depressed, release it.
3. Switch on the equipment’s power supply.
4. To start the equipment, press down the foot pedal using your foot. Always
hold on to the flexible shaft’s protection jacket with both hands while
pressing the pedal.
5. Starting the machine facilitates pushing the tool deeper into the pipe. Note
that depending on the pipe machined, if the machine is needlessly used at
locations other than the exactly required location, the pipe can be
damaged.
6. In order to convey optimal force, reel out at least 10m of the flexible shaft
from the machine.
7. The machine is equipped with a manual operating switch. If the foot pedal
is released, the machine stops. The machine can also be stopped by
pushing the red Emergency Stop button, by turning the power switch on the
control panel to the “0” position, or by unplugging the machine’s power
cord.
8. The service life of the flexible shaft’s protection jacket can be prolonged by
using Boldan cable sleeves on its ends.
!
V3 / 9.5.2022
