OPERATION MANUAL
RotoMax
7
Never forget:
The dust resulting from the use of this equipment can be hazardous to health,
flammable or explosive.
In order to prevent the formation of potentially hazardous or explosive sewage
gases in the pipe machined, make sure it is open and well-ventilated.
Prior to assembly, maintenance, tool removal, or parts replacement, remove
the machine’s power plug from the electrical outlet.
2.
3 Important safety instructions for use
Failure to comply can result in injury or death.
1. Always use safety goggles and hearing protectors, as well as protective
gloves and safety clothing. In case of dust-generating works, use respiratory
protection as well. Note that dust can be generated even if water is added
to the pipe machined while using the equipment.
2. Make sure the pipe to be machined is open and well-ventilated to prevent
formation of sewage gases in it. Tools used with the equipment can cause
sparks in the pipe. To prevent static electricity, the pipe must also be
properly grounded.
3. Prior to inspecting or servicing the equipment or before mounting any tools,
always make sure the equipment is switched off and the power plug
disconnected from the electrical outlet. When installing tools, follow the
applicable instructions.
4. Before each use, visually check that all machine parts are in order and
intact. Any damaged parts or components must be replaced before using
the machine. Pay special attention to the ends of the flexible shaft. The
shaft ends must be intact, unwinding of the ends is not allowed. If the end
of the flexible shaft is worn, it must be shortened by at least 50mm from
the damaged area in the undamaged direction.
5. Never leave the equipment unattended. If the equipment is connected to
power supply, the user must remain sufficiently close in order to disconnect
the power supply in case of an emergency.
6. While the equipment is in use, hold on to the flexible shaft’s protection
jacket with both hands.
!
V
2, 20.1.2021
