Bogen NYQUIST NQ-A4060, Руководство по настройке

Страница: 23 / 42

15
6.1 Setting the Channel Level
The Channel Level control is a vertical slider that is adjusted in 1 dB
increments and that controls the input or output levels to and from
the mixer. The Channel Levels can range from -60 dB to 12 dB. If you
place the mouse over the slider, the numerical value of the level
appears.
6.2 Signal LED, Clip LED, and VU Meter
To the right of the Channel Level control are the Signal and Clip LEDs
and the VU meter.
The green
Signal LED automatically illuminates when a signal is
being received. The red Clip LED automatically illuminates when the
signal is clipping., or attempting to deliver an output voltage or cur-
rent beyond its maximum capability. Clipping will distort the sound
and can damage a speaker.
The VU meter not only illuminates green, yellow, or red (depending
on the signal level) but also has a scale ranging from -60 to 0 to help
you indicate the actual signal level.
Noise Gate Eliminates low-level hiss, noise, or leakage,
particularly when there is a high level of
ambient noise.
Parametric EQ Uses a center/primary frequency to allow tai-
loring of the frequency content of an audio
signal.
Router Routes audio to different devices.
Settings Allows you to provide names and colors for
the input and output channels.
Signal Present Illuminates green when audio is present in
the channel input.
Status Provides real-time status of which mode (2-
channel or single channel bridge mode) the
power amplifier is configured.
Table 7, DSP Page (Continued)