Operation
Install Lectern Microphone
The gooseneck lectern microphone plugs into the three-pin receptacle located on the top of the lectern.
Connect Power
Use the power cord supplied. Plug one end of the cord into the receptacle on the lectern labeled AC LINE INPUT. Plug the
other end of the cord into a properly grounded three-wire AC receptacle.
Caution:
For safe operation, it is important to ground the amplifier properly. Do not attempt to defeat the grounding pin of
the 3-wire plug. If you use a “pigtail” adapter to connect the plug to a two-wire outlet, you must ensure that the adapter is
connected properly and that the outlet is properly grounded.
Apply Power
1
. Rotate the MIC and LECTERN MIC controls to their full counterclockwise positions.
2. Place the POWER switch in the ON (illuminated) position.
Adjust Volume, Bass and Treble
While speaking into the lectern gooseneck microphone, rotate the LECTERN MIC control to a comfortable listening level.
Rotate the BASS and TREBLE controls as necessary to enhance audio output.
Adjusting Reading Lamp
The lamp is controlled by the amplifier POWER switch. Use the switch on the lamp line cord to set the lamp to always on or
always off.
Page 5 of 8
