Boeco TC-PRO-3048, Инструкция по эксплуатации

Страница: 39 / 81

BOECO TC-PRO
Thermal Cycler Chapter Four Operation Guide
— 31 —
reminding information you can select “START” to continue. If you don’t make a decision
within 100 seconds, the system will continue running automatically.
 Press “ View File ” to view edited PCR programs.
 Press “ Skip ” to stop current temperature and run the next.

Press “Enter” key checking the grads temperature value.
4.2 How to set system parameters
In the main interface, press “ System ” to enter
system parameter setting interface
Press “Enter” to move the cursor to next item.
The option is followed by the symbol “ ”. Press
“Up/Down” to roll the option for selecting, and
other information can be entered information by
pressing
“Digit& Letter” . Press “Right/Left”
to move the cursor’s position.
 Press “ Back ” to go back to the main
interface.

Press “ Save ” to save the parameters.
Special Reminding: When set the parameter, please press the “Save”, otherwise the
parameter remains the original one.
NOTE
：
After set the parameter, please press “Save” to confirm setting, otherwise the
parameter remains the original one.
Before the instrument leaves the factory, its inside clock has been adjusted in
accordance with Beijing Time.
For the first use of the instrument, you are advised to confirm whether the date
and clock time are set right as local time.
4.3 Characteristics of Temperature Distributing of Gradient Block
The gradient block adopts 3-group temperature control units, so that the gradient temperature
appears curve distribution as showed in the following figure (Setting temp is 40
℃
, and gradient
setting temp is 20 ). The gradient distribution among every block’s hole temperature is not even;
the temperature difference in mid of block is larger than that of its outer. Therefore, please refer to
the temperature displayed on the machine for every hole’s temperature when operating gradient
block.
Hotlid=off 2007-11-1
10:05:00
Date: 03-10-22
Time: 14:53:19
Default User: BOECO
Default File: PCR1
Control Mode: Block
Hotlid: off
Key Sound: Yes
Run End Sound: Yes
Back Save
System Parameter Setting Interface