ASSEMBLY INSTRUCTIONS
BDEX2496.0
STEP 9
The Console (1) requires two 1,5 V “AA” batteries.
Remove the battery cover from the back of the
Console, and insert two batteries into the battery com-
partment. Make sure that the batteries are oriented
as shown by the diagram inside the battery com-
partment. Then, reattach the battery cover.
Have a second person hold the Console (1) near the
Handlebar Upright (4). Connect the console wire to
the Upper Wire (80). Connect the pulse wire on the
console to the Handlebar Upright Wire (24). Insert the
excess wire into the Handlebar Upright.
Slide the Console (1) onto the Handlebar Upright (4)
and attach it with two M4 x 10mm Screws (53). Be
careful to avoid pinching the wires.
STEP 10
Identify the Right Pedal (23), which is marked with a
sticker. Using the included wrench, firmly tighten the
Right Pedal
clockwise into the right arm of the Crank
(27). Tighten the Left Pedal (not shown)
counterclock-
wise into the left arm of the Crank. Important:
Tighten both Pedals as firmly as possible. After
using the exercise cycle for one week, retighten
the Pedals. For best performance, the Pedals must
be kept tightened.
Adjust the strap on the Right Pedal (23) to the desired
position. Then, press the end of the strap onto the
tabs on the Right Pedal. Adjust the Left Pedal strap
(not shown) in the same way.
PLEASE DO NOT RETURN TO STORE; CALL OUR CUSTOMER SERVICE DEPARTMENT FIRST AT
1-877-872-6970
11
Strap
Tabs
23
27
53
Console Wire
80
24
Pulse Wire
1
4
