BodyCraft BC-CABLE-PULL, Руководство по сборке

Страница: 17 / 32

(25) C AB L E
C 4,C 6
C 8
C 4
31
41
9
12
32
41
1
C 6
F ig.1 F ig.2
C 1,C 9
C 2,C 3,C 5,C 7
C 1
C 2
C 9
32
32
32
41
8
8
41
41
31
2
32
41
41
32
41
C 3
C 5
C 7
9
12
11
35
IMPOR TANT
17
Step 5: Install Cable
1. Screw the Double Pulley Bracket (9) into the Top Plate (12) with the Selector
Rod (11), see C4 and C6.
࣑
ATTENTION
The thread of the Double Pulley Bracket (9) must be screw into the Top Plate
(12) for at least 2 cm.
2. Insert one end of the Cable (25) into the front right side of the Swivel Pulley
Housing (8) and pull it out upwards. Mount two Pulleys with two 3/8“
X 1-3/4“ Hex Bolts (32) und zwei 3/8“ Nylon Nuts (41), see C1 und C9.
3. Run the Cable to the Top Frame (2) over Pulley C2 and C3. Mount Pulley
C2 with a 3/8“ X 1-3/4“ Hex Bolt (32) and a 3/8“ Nylon Nut (41) and
temporarily mount Pulley C3 with a 3/8“ X 2-3/4“ Hex Bolt (31) and a
3/8“ Nylon Nut (41), see C2, C3, C5 and C7.
4. Run the Cable down to the right-hand bracket of the Double Pulley
Bracket (9) and around Pulley C4 (Fig. 1). Temporarily mount Pulley C4
with 3/8“ X 2-3/4“ Hex Bolt (31) and a 3/8“ Nylon Nut (41).
5. Run the Cable to the Top Frame (2) over Pulley C5. Loosen the previously
mounted 3/8“ X 2-3/4“ Hex Bolt (31) and a 3/8“ Nylon Nut (41). Mount
the Pulleys C5 and C3 with the loosened bolt and nut.
6. Run the Cable down and
from behind around Pulley
C6. Loosen the previously
mounted 3/8“ X 2-3/4“ Hex
Bolt (31) and a 3/8“ Nylon
Nut (41). Mount the Pulleys
C6 and C4 with the loosened
bolt and nut.
7. Run the Cable to the Top
Frame (2) and around Pulley
C7. Mount the Pulley C7 with
a 3/8“ X 1-3/4“ Hex Bolt (32)
and a 3/8“ Nylon Nut (41).
8. Run the Cable down and
around Pulley C8. Mount the
Pulley C8 with a 3/8“ X 1-3/4“
Hex Bolt (32) and a 3/8“ Nylon
Nut (41).
9. Run the Cable from there
upwards and from below into
the Swivel Pulley Housing (8).
Mount two Pulleys with two
3/8“ X 1-3/4“ Hex Bolts (32)
und zwei 3/8“ Nylon Nuts
(41), siehe C1 und C9.