14
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until the last step.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
2A. Attach Angled Frame (
D
) to Mainframe (
A
) using:
2 - (#5) M12X100mm Hex Head Bolt
4 - (#10) 12mm Flat Washer
2 - (#7) M12 Nylon Lock Nut
2B. Insert Nylon Bushing into Angled Frame (
D
) using:
1 - (#17) 30X70X100mm Nylon Bushing
2C. Screw Gear Pin into Angled Frame (
D
) using:
1 - (#18) Gear Pin
2D. Insert Adjustment Frame (
E
) into Angled Frame (
D
).
2E. Attach Handle Frame (
F
) to Adjustment Frame (
E
) using:
2 - (#3) M10X85mm Hex Head Bolt
4 - (#9) 10mm Flat Washer
2 - (#6) M10 Nylon Lock Nut
2F. Insert End Caps into square ends of Handle Frame (
F
) using:
2 - (#16) 30X30mm End Cap
Содержание GHYP-345
