12
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until the last step.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Base Frame (
B
) followed by Flate Plate (
H
) to
Mainframe (
A
) using:
2 - (#4) M12X75mm Hex Head Bolt
4 - (#10) 12mm Flat Washer
2 - (#7) M12 Nylon Lock Nut
1B. Attach Foot Frame (
C
) followed by Flate Plate (
H
) to
Mainframe (
A
) using:
2 - (#11) M12X80mm Hex Head Bolt
4 - (#10) 12mm Flat Washer
2 - (#7) M12 Nylon Lock Nut
1C. Insert Foot Caps into ends of Foot Frame (
B
) using:
2 - (#15) 75X50mm Foot Cap
1D. Insert Foot Caps into ends of Base Frame (
C
) using:
2 - (#13) 50X50mm Foot Cap
Содержание GHYP-345
