Body Solid G3S, Руководство по сборке

Страница: 10 / 33

5
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
10
S T E P
NOTE:
You will need to loosen two Allen Screws (76) inside Seated Press Arm Support (P) to
remove Shaft (71)
A. Attach Seated Press Arm Support (P) to Top Frame (E) with Shaft (71). TIghten Allen Screws (76)
in Seated Press Arm Support (P). Oilite Bushings (74) are pre-installed.
NOTE:
You will need to loosen two Allen Screws (76) inside Seated Press Arms (Q) to remove
Shaft (72)
B. Attach Seated Press Arms (Q) to Seated Press Arm Support (P) with Shaft (72). Tighten Allen
Screws (76) inside Seated Press Arms (Q). Plastic Bushings (75) are pre-installed.
Make sure Pop Pin (77) in Seated Press Arms (Q) is fully engaged into selector hole in Seated
Press Arm Support (P).
C. Attach two Flat End Caps (2) to the top of the Seated Press Arm Support (P).
Attach two End Caps (5) to the top of the Seated Press Arm (Q).
D. Attach the Right Seated Press Handle (R) to the Seated Press Arm (Q) as shown using:
Three 80 (3/8” x 5/8” allen bolt)
Three 56 (3/8” curved washer)
Tighten the three Allen Bolts (80).
Insert two Round End Caps (100) and one Small Round End Cap (28) into Right Seated Press
Handle (R) as shown.
E. Attach the Left Seated Press Handle (L) to the Seated Press Arm (Q) as shown using:
Three 80 (3/8” x 5/8” allen bolt)
Three 56 (3/8” curved washer)
Tighten the three Allen Bolts (80).
Insert two Round End Caps (100) and one Small Round End Cap (28) into Left Seated Press
Handle (L) as shown.