A s s e m b l y S t e p 2
Pivot Tube (See Note)
BRD 3700/2800
Page 6
Note:
Make sure
Left /Right Coupler Bar (04L/04R)
are placed on the correct side when its horizontal Pivot Tube (which is
welded at the top) faces the
REAR
of the machine as seen from the user.
Washer
#56 Washer
(φ10.2xφ25x2)
[2 Pieces]
#45 Nylon Nut (M10)
[2 Pieces]
Others
#
12 Handlebar
Axle (φ16x410 mm)
[1 Piece]
#42 Cap
(S16)
[2 Pieces]
Tools
#68 T
ool 1 (2-S17,S19)
[2 Pieces]
Hardware & Tool Required
Remove the
Nylon Nuts (#45)
and
Washers (#56)
that
are pre-assembled on the
Handlebar Axle (#12)
and set
them aside as they will be used in a later process.
Insert the
Handlebar Axle (#12)
through the main frame.
Make sure the
Handlebar Axle (#12)
is centered. If you
encounter too much friction, try using WD40 or
Vaseline as
a lubricant.
attach
Left Coupler Bar (#04L)
and
Right Coupler Bar
(#04R)
to the main frame via the
Handlebar Axle (#12)
.
Again, use WD40 or
Vaseline to reduce friction if needed.
Once the
Left Coupler Bar (#04L)
and
Right Coupler
Bar (#04R)
are correctly situated, fasten the end of the
Handlebar Axle (#12)
with a
Washer (#56)
and a
Nylon
Nut (#45)
on each side. Then cap each end with a
Cap
(#42).
55
40
1
2
3
4
STEP3:
Assembly Instructions
Please refer to the “Note:” and image below and properly
101
101