Assembly Instructions
#17. Washer (M10)
[8 pieces]
#20. Curved Washer (M8)
[6 pieces]
Nut
BOLT
#16. Carriage Bolt (M10x65 mm)
[8 pieces]
#19. Bolt (M8x75 mm)
[4 pieces]
Washer
Page 6
Hardware Required
Assembly Step 2
With the help of an assistant, align and attach the
Upright (#05)
to the
Base Frame (Right) (#02)
. Insert two
Carriage Bolts (#16)
through the
Base Frame (Right) (#02)
and
Upright (#05)
. Secure
them together using two
Washers (#17)
and two
Lock Nuts (#18)
.
Repeat this process on the other side.
Align and attach the
Upright Angle Support Frame (#04)
to the
Upright (#05)
and
Base Frame (Right) (#02)
. Insert two
Carriage
Bolts (#16)
through the bottom of the
Base Frame (Right) (#02)
followed by the
Upright Angle Support Frame (#04)
. At this point
hand tighten the two
Washers (#17)
and two
Lock Nuts (#18)
on
the lower portion as it may be difficult to align the holes for the upper
portion. Insert two
Bolts (#19)
through two
Curved Washers (#20)
followed by the
Upright (#05)
, and
Upright Angle Support Frame
(#04)
. Secure them together using one
Curved Washer (#20)
and
one
Lock Nut (#15)
. Repeat this process on the other side. At this
point, secure the
Lock Nuts (#18)
that were hand tightened in the
lower portion. Repeat this process on the other side.
#15. Lock Nut (M8)
[2 pieces]
#18. Lock Nut (M10)
[8 pieces]
PT600/628/810
NOTE:
For easier assembly, only hand tighten the Nuts
& Bolts for now. After all parts have been put in
place, then proceed to tighten with a wrench.
