Page 9
Assembly Instructions
A s s e m b l y S t e p 5
The assembly process is complete; however, please read all safety
instructions in this manual as well as any safety/warning labels on
the unit before use.
Please ensure all nuts, bolts and knobs are securely tightened before using the unit.
A.) Remove the two
Screws (#55)
that are pre-assembled on the back of the
Monitor
(#09)
and set them aside as they will be used later in this step.
Connect the
Handle Pulse Wire (Lower) (#50)
to the
Handle Pulse Wire (Upper)
(#67)
and connect the
Main Sensor Wire (Middle) (#18a)
to the
Main Sensor Wire (Upper) (#66).
Secure the
Monitor (#09)
to the bracket on the
Front Post (#02)
using the two
Screws (#55)
that were previously removed.
B.)
Remove the Washers and Nuts that are pre-assembled on the back of the
Seat (#69),
then remove the
Knob Bolt (#68)
that is pre-assembled on the
Main Frame (#01)
and set
them aside as they will be used later in this step.
Slide the
Seat (#69)
onto the
Horizontal Seat Bar (#71)
, ensuring that it is positioned as
shown in the illustration below, then tighten with the three
Washers (#70)
and
Nylon Nuts
(#78)
that were previously removed. Assemble the
Horizontal Seat Bar (#71)
onto the
Seat
Post (#76)
by inserting the end of the
Horizontal Seat Bar (#71)
through
Seat Post (#76)
as
illustrated below and secure with one
Washer (#74)
and one
Knob (#75)
. This knob can be
loosened to adjust the distance of the seat from the handle bars. Make sure to tighten the
knob after making an adjustments. Insert the
Seat Post (#76)
into the mouth of the post
protruding from the
Main Frame (#01)
down a minimum of 4 inches to engage the lowest
hole. Please ensure that the hole on the
Seat Post (#76)
facing the same side as the
Knob
Bolt (#68)
so it can be aligned and fully engage through the lowest corresponding hold on
the
Main Frame (#01)
.
Screw in the
Knob Bolt (#68)
through the
Main Frame (#01)
post
and fully through (at minimum) the lowest hole located on the
Seat Post (#36).
Please refer
to illustration. You may adjust the
Seat Post (#76)
to the height most comfortable for you
after complete assembly. Please always check to ensure a hole has been fully engaged
when you secure and tighten the
Knob Bolt (#68).
Hardware Required
After complete assembly: If the computer
is
not picking up your hand pulse signal
(or you are getting inaccurate readings),
Please refer to our “Troubleshooting”
section on
Page 12
for other troubleshoot
issues.
HAND PULSE SIGNAL
Troubleshooting
#55. Screw (M4x12 mm) [2 Pieces]
Bolts
Washers
Nuts
Others
#70. Washer
(M8)
[3 Pieces]
#74. Washer
(M10) [1 Piece]
#78. Nylon Nut
(M8) [3 Piece
s
]
#68. Knob Bolt (M12)
[1 Piece]
#75. Knob (M10)
[1 Piece]
BRM2170/2180
FRONT
OF UNIT
