20
10
16L
40
20
10
40
18
4
4
18
16R
7
assembly instructions
With the help of an assistant, attach the
Left Handle Bar (#16L)
to
the
Center Post (#7)
. Insert two
Bolts (#40)
through two
Spring
Washers (#10)
, two
Arc Washers (#20)
then
Left Handle Bar
(#16L)
and
Center Post (#7)
. Screw the
Bolt (#40)
securely into the
Center Post (#7)
.
WIRE CONNECTION:
A. Remove
Wire Plug (#8)
from the
Center Post (#7)
being careful
not to pull on the wires (you do not need to remove the wires).
B. Carefully connect the heads of
Hand Pulse Sensor Wire (Upper)
(#4)
to the heads of
Hand Pulse Sensor Wire (Lower) (#18)
.
C. 1.
Remove the Wire Plug (#8)
from its current position on the
Hand Pulse Sensor Wire (Upper) (#4)
and then,
2. Transfer the
Wire Plug (#8)
back onto the
Hand Pulse Sensor
Wire (Upper) (#4)
on the new location -- the outer side of the
connected heads (this will allow you to tuck in the connected
heads and wires in next step).
D. Tuck the connected heads and wires into the hole on the
Center
Post (#7)
and carefully insert the
Wire Plug (#8)
back into the
Center Post (#7)
.
Repeat this process on the other side using
Right Handle Bar
(#16R)
.
S T E P 5
P A R T S
x4
#10
x4
#40
x4
t e n s i o n a d j u s t m e n t
To increase the tension (+ higher level of intensity), turn the
Tension Controller (#6)
in a clockwise direction.
To decrease the tension (- lower level of intensity), turn the
Tension Controller (#6)
in a counter-clockwise direction.
"1" is the lowest level of tension (easiest level for workout);
"8" is the highest level of tension (most difficult level for
workout).
A
C
B
D
Remove #8 to transfer
Tuck in wire, then insert in #8
LEFT
SIDE
Remove #8 to transfer
Tuck in wire, then insert in #8
RIGHT
SIDE
4
8
18
7
18 4
8
4
18
1
2
7
8
16L
16L
7
8
7
8
16R
2
16R
7
8
1
8
7
HBR35
Page 10
#20
