Body Champ BRM 3671, Руководство пользователя

Страница: 14 / 24

BRM3671/3690/3171 Page 13
Assembly STEP 7
**Do not remove the Seat (#36) for any reason after you
have installed it. Exercising on this unit without the
Seat(#36) can result in SERIOUS INJURY.
Ensure the seat is locked in place by ightening the two
knobs prior to use.
(#67) 1/4" Bolt Cover
[2 Pieces]
(#66) M10 Bolt Cover
[2 Pieces]
(#65) M8 Bolt Cover
[2 Pieces]
(#44) Washer (M8)
[3 pieces]
(#41) Nylon Nut (M8)
[3 Pieces]
(#28) Knob Bolt
[2 Pieces]
Hardware Required
Remove the three Washers (#44) and three Nylon Nuts
(#41) that are pre-assembled on the back of the Seat (#36) and set
them aside as they will be used later in this step.
Attach the Seat (#36) onto the Horizontal Seat Bar (#11) and
make sure that the Seat (#36) is pointing directly toward the short
end of it and then tighten with three Washers (#44) and three
Nylon Nuts (#41) that were previously removed.
If pre-assembled, remove the Knob Bolt (#28) on the mouth of the
Main Frame (#01) . Insert the S eat Post (#10) into the mouth of the
post that is protruding from the
Main Frame (#01)
down a minimum
of 4 inches to engage the lowest hole. Make sure the holes on the
Seat Post (#10) are facing the front before inserting. Secure
the Seat Post (#10) (now with Seat (#36) attached) using the
(previously removed) Knob Bolt (#28).
The Knob Bolt (#28) can be loosened to adjust the distance of the
seat from the handle bars. Make sure to tighten the knob after
making any adjustment.
Attach Handle Bar Cover (#68) onto the Pulse Handle Bar (#09),
Bolt Covers (#65), (#66), (#67) each 2 pieces onto the Bolts as
illustration below,