INSTALLATION INSTRUCTIONS
Removing Bumper:
Step 1 Remove the (2) push-pin screws to remove the plastic frame cover-plate.
Step 2 If equipped, disconnect the OE driving lights at the back of the light housings. Insulate
ends and tie the wires to the frame. Do not cut ends.
Step 3 Using appropriate tools, remove the OE front bumper by removing the hex nuts holding
the bumper to frame mount flanges. Installation kit contains all new necessary attaching
Installation:
Pre-Assembly:
Step 1 Attach the logo plate to the front face of the bumper by using the 1/4" round head alien
drive bolts and nylock nuts. In states that require a front license plate you can mount it in the
same area by using the holes provided.
Step 2 Attach the fare lead bracket using four of the 10MM-30MM hex bolts, washers not
required. Attached the fare lead that is comes with the winch, using their hardware.
Step 3 If installing the Body Armor 50018 LED light bar install the light prior to installing
the bumper by using the sliver flat plate and 1/4" hex bolts. The light mount to the two tabs
located under the winch plate. The silver plate inserts on top of the tab, use the bolt to attach
the bracket that comes with the light.
Step 4 Insert large plastic caps in the round tubes connecting the hoop
Step 5 If installing bumper wings attach them prior to installing the bumper on the vehicle. Use
the hardware that is provided with the bumper wings. Attach them to the three holes on each
side of the bumper, keep loose until all hardware is attached, then tighten. Attach OEM fog light
using the brackets proceed on JK-19536-WR. Install cube lights on JK-19536-WC hardware for
your Body Armor JK Bumper. The Plastic bumper face is separate from the internal frame.
Bumper installation:
step 1 Lift the bumper and place over the over the frame horns so that the 8 holes in the
cutouts line up. Have a helper stabilize the bumper. Locate the shackle plates. Insert the
shackle plates into the pockets. The angle of the face of the shackle plates match the angle of
the face of the bumper. Insert four 10M-30M bolts into the four holes that are provide. The bolt
needs to pass through the plate face through the frame horn. Attach the back side of frame
horns on each bolt a flat washer followed by the 10M hex nut. Keep all hardware loose for now.
