7
STEP #10 - Install Brush Caps
If the brush caps were damaged during their removal and need to be replaced,
record the motor type and serial number from the motor nameplate. Contact
your supplier, any Authorized Bodine Distributor, or our Service Department.
You can find more information on how to contact Bodine Electric at:
www.bodine-electric.com
Screw brush caps back into the end shield using largest possible screwdriver.
STEP #11 – Connect to Power
Reconnect the drive to the power source, and test for proper operation. New
brushes may be seated by running the motor or gearmotor in at no load. Proper
seating is required for lowest brush noise level.
All information and data contained in this document are subject to change
without notice. Please contact our Technical Support staff in Chicago, or an
Authorized Bodine Service Center, if you have any questions about these
instructions. Copyright Bodine Electric Company 2007. All rights reserved.
Figure 14 – Drawing of how spring should be installed in brush box.
