6
2.1.2 Mounting with back cover
According to the model of the clock make the cut-out following the dimensions listed in table below
Dimensions in mm
- Insert the back cover in the cut-out tn order to mark the position of the mountig screws.
a) Remove the back cover and drill 2 holes Ø 6 mm ( ) to insert the wall plugs.for the back cover
mounting
b) Drill 4 holes Ø 10mm ( ) to make room for the back cover clock mounting rivets.
c) Feed the power cable, the synchronisation cable and the keypad cable throught the cut-out and
cable glands of the back cover
d) Fix the back cover to the wall with the 2 screws Ø 4mm
e) Connect the clock, adjust the brightness (page 7) and set the time (refer to page 10)
f) Fix the clock to the back cover with the 4 screws Ø 4mm
A
B
C
D
E
Style 5S OP
46
400
365
68
107
Style 7S OP
440
404
85
123
Installation
with
the back cover
Back cover mounting screws
X
Y
X
Y
Y
