Bodet Profil TGV 950, Инструкция по установке и эксплуатации

Страница: 7 / 12

7
■ During 1 hour without reception of the time signal the clock operates with its own time basis. If
the signal recovery is achieved within this hour, the clock will be resynchronised automatically.
After 1 hour the clock is reset and hands are set on position 12.00.
■ Without power supply 230V the clock operates with its battery during 1 hour. After 1 hour
without time signal reception or if the battery voltage drops down, hands are set position 12.00
until power supply recovery.
■ The synchronous second hand witch is powered by the main 12V 50Hz, will stop immediately.
3.2.3. Radio receiver clock
■ Switch off the circuit breaker involved.
■ Connect the mains 230 V +/-10% 50 Hz to the
terminal (6) (Live, Neutral and Earth wires; section
1.5 mm² to 2.5 mm² and bare on 5 mm). The mains
cable must be oversheathed up to the terminal.
■ Attach the 3 wires (Live, Neutral an Earth) with the
cable tie.
■ A double/reinforced electrical insulation must be
assured between the mains cable and the SELV
wires.
■ Connect the two wires of the antenna to the
terminals 4 and 5 of the electronic card.
■ Check that the dip switch (16) is in receiver position.
■ Check that the battery is connected to the terminal (2) of the electronic card.
■ Lock the clock.
■ Push the dip switch (15) to the ON position.
■ Close the clock.
■ Power the clock.
Operating principle of radio receiver clock
■ When switching on power supply, hands are set
at 12.00 until the correct reception of the time
signal is achieved. After 3 successive coherent time signals are received, the clock starts and
automatically get on time with fast impulses.
■ Once the clock is synchronised, it operates with its own time basis. If the signal is back within
this period, the clock set itself automatically.
■ Without power supply 230V the clock operates with its battery during 1 hour. After 1 hour
without time signal reception or if the battery voltage drops down, hands are set position 12.00
until power supply recovery.
■ The synchronous second hand witch is powered by the main 12V 50Hz, will stop immediately.
5
6
4
3
3
1
15 16
AF FI
Input 162