4
II - Mounting behind basetball backboard
1/ According to the type of basketball boards, extend the support mast (60 × 30 tube) for each display
until it reaches the final position (regulation distance for dimensions L).
2/ Fix the shoe with 4 threaded flat washers and plywood to the beam of the basketball board.
3/ Fix the 2 U sections to the mast (level depending on model).
4/ Position the mast in the shoe with 1 HM10×90 screw, 1 HU M10 nut and Ø10 flat washer.
5/ Rotate the mast vertically, then lock it with a HM10×90 screw, 1 HU M10 nut and Ø10 flat washer
to the opening of the shoe.
6/ Fix the display to the mast with H M10x30 bolts, HU M10 nuts, Ø12 flat washers and Ø10 washers.
7/ Check the distance L (30 to 50 cm). Countersink the tube to Ø11 in the final position and screw
down hard with a HM10×90 screw crossing the tube, 1 HU M10 nut and Ø10 flat washer.
III - Wall mounting
1/ Install the 8006 on the wall using 4 screws and rawlplugs respecting the dimensions between the
bracket holes as shown below:
A
A
581 mm
HM10x90 screw
Ø10 flat washer
HU M10 nuts
M10x185 threaded shaft
Ø10 flat washer
HU M10 nuts
HU M10 nut
M10x50 screw
Pivot axis
Countersink the tube to Ø11 in the vertical position
to hold the display unit in the fixed and final position.
With 1x H M10x90 screw and 1x HU M10 nut.
Basketball backboard arm
(100 to 140 square tube).
Cut the tube
Cut the tube
581
360
Shoe