Boca BASIC VGA VGA006, Руководство по установке

Страница: 26 / 40

26
BASIC VGA by BOCA
E.4 AutoCAD ADI 4.0 Display List Driver
(Rel. 10)
Introduction
The Basic VGA is supplied with a combination ADI v. 4.0 and display
list driver that supports AutoCAD release 10 and other AutoDesk DOS
(non-386 protected mode) products. Whether or not a display list is
implemented depends on the presence of sufficient expanded system
memory. See Memory Requirements below. The driver package
consists of two files:
ADICFG.EXE
(a configuration program for the
driver) and
BVGAADI.EXE
(the driver itself).
Before you install the
BVGAADI
4.0 driver, it is recommended that
you install AutoCAD according to the instructions found in the
Installation and Performance Guide that accompanied your AutoCAD
package. Then, start AutoCAD and configure the display option for
IBM Video Graphics Array (VGA). This allows you to run AutoCAD
on the Basic VGA in standard VGA mode to verify correct installation
and operation.
Memory Requirements
This ADI 4.0/display list driver uses expanded memory to implement
its display list. If there is not enough memory available for the display
list, then none will be implemented. While AutoCAD release 10 can
make us of either extended or expanded (EMS) memory, you should
have at least one megabyte of expanded memory available if you wish
to take advantage of the display list portion of this driver.
If expanded system memory is available when the driver is started,
approximately half of this memory will be allocated to AutoCAD and
half to the display list.