BobsCNC E3, Инструкция по сборке, Страница: 5 / 90

Page 5
Required Tools
To assemble the kit together you will need the following:
•
Two ½ ” end wrenches to tighten Z Bearing nuts.
•
A pair of long nose pliers to hold the nuts.
•
Diagonal Cutters or sharp knife to trim nylon ties.
•
Calipers or measuring tape to measure part placement.
•
Small standard screwdriver to connect electronics.
•
Small Phillips screwdriver to mount home switches and stepper motors.
•
Medium Phillips screwdriver to build the main components.
•
Sand paper to remove laser marks on the faces.
•
M4 Star Driver for DeWalt disassembly.
•
LOCTITE 243 thread lock (fingernail polish can be used as a substitute).
To operate the E3 CNC Router you will need:
7/16” & 5/8” wrench to change router bits.
Computer with control software for GRBL.
Build material.
1/8” or 1/4” Router bits.
Dry lubrication (e.g., graphite, Teflon or silicon spray).
Tools you may need for the electronic setup include:
Multimeter to correctly connect the power supply and stepper motors. A multimeter is also a good tool to have for
general electronic trouble shooting.
Quick Start and Troubleshooting guides are available to help you get up and
running. Please check BobsCNC.com for the latest version.
Getting Started
•
We recommend using a large flat, clean working surface for assembling your E3.
•
All screws (unless noted) should be installed snug, then rotated one 1 to 2 1/2
turns.
•
Light sanding of the wood surfaces will clean up the marks made by the laser.
•
Painting or applying stain with a clear coat will give added protection to the wood
*For More Information: Click on the Links
*Look for Good Ideas