Bob’s Space Racers
®
Inc. ©1976-2019
3-1
Chapter 3: Maintenance Tip
3.1 Unclogging a brass tip of a water gun.
3.1.1
This easy step-by-step process will show how to unclog the brass tip of a water gun.
Water Gun
Tools Needed
➢
3/8” Open-Ended Wrench
➢
Drill Bit #59 or
BSR Gun tip Cleaner.
BSR Part # M0006104
➢
Small Bucket
Note: Using anything other than the suggested tools
could cause unwanted damage to the Brass Gun Tip
and is not recommended.
Figure 3.1
3.1.2
Removing Gun Tip
3.1.2.1
Using the 3/8” Wrench, remove the brass gun tip by turning the brass gun tip
counter-clockwise until the brass gun tip and the rubber washer,
BSR Part # M0006308,
come off of the end of the gun.
Water Gun Barrel
Water Gun Tip
Figure 3.2
Figure 3.3
Note: Do not misplace the fiber washer, it is needed to form a good seal around the gun tip and prevent water
leaking from the gun tip.
3.1.3
Unclogging the brass tip.
3.1.3.1
Carefully insert drill bit into brass gun tip.
3.1.3.2
It may be necessary to blow air through gun tip to remove any remaining debris.
Inserting
Removing
Figure 3.4
Figure 3.5
3.1.4.
Clearing the line.
3.1.4.1
Use a small bucket or pan to catch any water that comes from the water gun. With
tip removed from gun start the race. This will flush out any debris from the water line.
Note: After clearing the line just re-install the gun tip. Do Not Overtighten the Brass Gun Tip
