Bob’s Space Racers
®
Inc. ©1976-2019
ii
A. Introduction
A.1 Overview
This manual contains informative information about Water Gun Fun™ Pixel Play™ Arcade water game.
Such as: Setup, instructions how to play, maintenance, tech tips, troubleshooting, game options settings, and
service. Appendixes A-C contain information about policies, warranty, and service. Appendix D has a
choice selection of parts pertaining to this specific game.
A.2 Use only a GROUNDED AC Receptacle.
Failure to do so could result in improper operation or damage to the game and could void your warranty. If
you are unsure that your AC receptacle is properly grounded, have a qualified electrician perform this check
for you.
A.3 Maintenance for the games
Always be sure power to the game is turned off when performing even routine maintenance. Otherwise
moving parts could activate unexpectedly and cause injury.
A.4 Average Power Requirements
Amperage & Watts will vary depending on game.
Voltage
Amps
Watts Hertz
Service Power
Recommendation
A.4.1
Domestic Game Power:
110V ± 10V
~ 5.42 Amps
~ 650 W at 60Hz
10 Amps
A.4.2
Export Game Power:
220V ± 10V ~ 2.71 Amps ~ 650 W at 50/60Hz
10 Amps
WARNING!
Ensure that this product is compatible with your facilities power supply, voltage and frequency requirement.
A label describing Electrical Specifications is attached to the product. Non-compliance with the Electrical
Specifications can cause a fire and electric shock. Ensure the game is level before applying power.
A.5 Check Packing List
Check the packing list prior to installation. Verify that all parts that have been received and are in good condition.
Figure A.1
Figure A.2
Figure A.3
Figure A.4
Arcade
Stool Post
Foot Board
Seat
Figure A.5
Figure A.6
Figure A.7
Seat Hardware
Back Secure Bolts
Game Power Cable
