10
CAUTION:
READ ALL WARNINGS BEFORE USING OR ATTEMPTING ANY WORK ON
YOUR MARKER. SHOULD YOU BE UNSURE AT ANY POINT, STOP AND SEEK
PROFESSIONAL SUPPORT.
Maintaining the bolt
1.
De-gas the marker and insure that there
are no paintballs in the breech or barrel
of the marker.
2.
Remove the bolt from the marker by
pulling upward on the pull pin.
3.
Slide the bolt to the rear of the marker
body.
4.
Inspect the surface of the bolt and o-
rings for excessive wear or nicks, and
replace as necessary.
5.
Place one drop of oil on each o-ring and
spread it around the ring with your
finger to ensure an equal coating.
6.
Inspect the breach and body – if
necessary run a clean swab through the
body to clean out any dust or debris.
7.
Reinsert the bolt into the marker
ensuring to place the pin into the
groove of the ram.
Maintaining the Ram
1.
Remove the bolt from the marker
2.
Remove the back cap retaining screw
from the marker
3.
Remove the back cap
4.
Tap the ram out into the palm of your
hand – if you have trouble tapping it out
use a hex key or chopstick to push it back
from the top where the bolt sits.
5.
Wipe off any old grease or debris.
6.
Wipe out any old grease from the ram
housing using a swab.
7.
Inspect the o-rings for excessive wear or
nicks, and replace as necessary.
8.
Apply a thin coat of grease to the o-rings.
9.
Reinsert the ram with the smaller
diameter section to the front of the
marker.
10.
Replace the back cap by placing the
bottom of the cap into position and then
rotating the top into position. This will
prevent the o-ring from shifting during
installation.
11.
Install the back cap retaining screw.
2
4
10
