BOB Gear REVOLUTION FLEX, Руководство пользователя

Страница: 6 / 31

6 7
BOB Gear REVOLUTION FLEX User Guide
2� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 9.
3� Insert Front Wheel
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with the holes in the fork blades.
4� Insert Through-Axle
Insert the through-axle into the
fork and through the wheel hub,
then install the nut to the opposite
side.
5� Tighten Through-Axle
Hold the nut in place, and use
the hex wrench provided to fully
tighten the through-axle. Pull on
wheel to check that it is securely
installed and does not wobble.
Stroller Operation
Unfolding and Folding
Unfolding the Stroller
1� Lift Red Frame Release Handle
Keep tires on ground as stroller
swing arm begins to swing open.
NOTE: Stroller swing arm will
swing open and snap into an
open and locked position.
2� Rotate Handlebar
Lift handlebar up and back until
it snaps into locked and upright
position.
Front Wheel Removal
1� Rotate Front Fork Into Jog
Mode
Rotate the front fork until it locks
into jog mode. See page 9.
2� Remove Through-Axle
Hold the nut in place and use
the hex wrench to loosen the
through-axle. Then remove the
through-axle from the front wheel
and fork.
3� Remove Front Wheel
Raise the front wheel a few inches
off the ground and tap the top of
the wheel with the palm of your
hand to knock the wheel out of
the front fork.
Front Wheel Installation
1� Remove Through-Axle and Hex
Wrench From Storage Bag
Remove nut from through-axle.
Check the front wheel before
each use of the stroller to
ensure it is properly secured�
Failure to secure the front
wheel can cause the wheel to
vibrate, wobble, or become
detached from the stroller�
FALL HAZARD - Wheel can
detach and cause tip over� Pull
on the wheel to assure it is
securely attached�
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2� Remove Wheel
Raise the wheel a few inches off
the ground, pull the release lever,
and pull the wheel out of the rear
wheel attachment bracket.
Nut
Through-
Axle
Hex
Wrench
Nut
IMPORTANT: Secure and safely
store all small parts.