7
6
7 of 8
iii) Click <
OK
>. –
i. If the message “We should download new
firmware” appears, click <
OK
>.
ii. If you get an error, disconnect and reconnect
the QSK from the USB cable and retry.
d) Click on the “Reset Go” icon to start the program.
e) Click on the “Stop” icon to halt the program.
f) From the “File” pull-down menu, select “Exit”. If
requested to save workspace and/or session, click
<
Yes
>.
Downloading (Re-Loading) the Demo Program
Using HEW as a Programmer
You can use the debugger and HEW to restore the original
demo program.
a) If not done already, plug one end of the USB cable
into the QSK board and the other into a USB port on
your PC.
b) Start HEW as in the previous section and select
“
Program Flash
” as the mode. The power section is
set as before.
c) When programming is competed a dialog with
a checksum will appear, and then a message to
disconnect the emulator. Click the “Disconnect”
button on the toolbar.
What are the next steps?
After you have completed this QuickStart procedure,
please review the tutorials that came with the kit.
The tutorials will help you understand and jumpstart
the software development process using Renesas’
development tools.
You can access the sample code tutorials for your
specific kit via the new project wizard or by browsing to
the “C:\Workspace\QSK_62P_Plus” directory on
your computer
