h) After ensuring there are no errors, proceed to 5: HEW
(Debugger) QuickStart.
NOTE:To learn more on how to use HEW, open the
HEW Manual Navigator on your computer (Start > (All)
Programs > Renesas > High-performance Embedded
Workshop > Manual Navigator).
HEW (Debugger) QuickStart
a) If not already done, plug one end
of the USB cable into the QSK
board and the other into a
USB port on your PC.
b) Use the Session pull-down box and
select “SessionM16C_E8_System” as shown.
If requested to save the session, click <
Yes
>.
c) Click the <Connect> tool button; The “Emulator
Settings” dialog box opens. In this dialog, you need
to select if the downloaded program will run under
debugger control or “stand alone”:
i) Click <Erase Flash and Connect> to use the
debugger. Click
<Program Flash> to
allow the program to run
independently.
ii) In the “Power Supply”
section, check <Power
Target from Emulator>
and click <3.3V>.
Note:
The board is
already powered up. The
purpose of this selection is
to let the reduced function
debugger located on the
board “see” the voltage
and operate normally.
See the User Manual for
additional Information.
5
Figure 6: Emulator Setting
Dialog Box
Figure 5
